Ring chain hoist the use of principles

Lifting load must be within the rated load, no overload use.

Safety clutch is a protective effect on the body up, as it cannot travel switch.

The chain should be lubricated before use. The chain can not be as a spreader.

After unloading the placed under the hook device should pay attention to, below the hook device cannot be reversed, otherwise the chain because of distortions at the entrance card to death。super-low electric chain hoist

In the operation of hand switch can not make the button contact in one state, in order to avoid the button to create a cremation and premature failure, such as found indirection and hoist hand motion direction switch the arrow is not, then you need to adjust the power phase sequence to achieve consistency.

‍

electric hoist

Push three phase electric hoist called push type micro electric hoist, operation Voltage of 220V daily voltage, inherits all advantages of similar productsPoint, and to push the form of mobile and fixed die, electric Hoist, when in use more flexible, thePoint is the practical design, very reasonable.Below we have a look push type electric hoist to protect The security certificate job have what characteristics:

1, after multiple quality system certification, safety performance and operationperformance of the mechanism on can be assured;

2, with emergency stop limiting function, protection grade is very high, and its insulation performance is very good;

3, not only can be used alone, can be matched with the monorail trolley in I-steel, joboffers non

Very large space, saving more time.

Above is the push content type wind tubine hoist related, the products are mainly used inspraying workshop, factory, machinery

Parts assembly, SSDHL electric chain hoist  logistics and transport and other occasions, the use of very wide range.

The uninterrupted operation how to choose the electric hoist

General 2.2m/min electric chain hoist is strictly prohibited Although the purchase money products more than doubled, but from a long-term point of view, it is the correct approach. Because the 25 ton electric chain hoist 24h uninterruptedoperation for a long time will lead to serious wear, serious shorten the service life, but the long-term use of the motor is easy to broken, take turns using electric chain hoistelectric hoist products can be effectively used, and will not cause excessive wear andscrapped gourd. uninterrupted operation, but special circumstances require long time operation, the best choice of chain type electric hoist.Such as factories and 4 electric hoist operation, but because or continuous operation,therefore need to purchase 8 sets of electric hoist used in turn.

Uninterrupted use is very easy to cause the electric hoist safety accidents, in order towork safety, suggest multiple electric hoist shift operation.‍

CDD electric chain hoist‍

Manual Block the load and momentary overload are greatly improved

one of the main components Detailed hoist electric hoist control box, look hoist control box structure : control box by a transformer box, contactors, terminal blocks and other components of electric chain hoist control box using machines with high-quality electric winch hoist contactor , the load and momentary overload are greatly improved, can get better more suitable for frequent operation of lifting appliances needed ; protection of high quality cold rolled steel sheet stretch forming , electrostatic spray . Different lengths are also available upon request and multi-core cables flashlight door ; After the control box lid opened, detachable from the hinges , user-friendly installation and maintenance ; control box has to take the electrical and mechanical interlock chain , so that the same two groups of contacts can not be simultaneously connected to geared trolley the circuit ; each control box is equipped with electrical schematics, wiring terminals have clearly consistent with the schematic number , user maintenance, wiring.
     The following is a hoist control box work conditions :
1 ambient air temperature is -20 ℃ ~ +40 ℃;
(2) Relative humidity: lowest average humidity is 90 %, while the average minimum temperature for the month was 25 ℃, and taking into account the temperature changes in the surface of the product Cream ;